A vessel manufacturer may choose to register a vessel design in other provinces or territories in addition to Alberta. The Alberta Boilers Safety Association (ABSA) offers a one-window service to boiler and pressure vessel manufacturers wishing to register their designs in multiple Canadian provinces and territories. The vessel manufacturer makes one submission and deals with one agency. The following describes the process and documents required for ABSA to apply for a vessel design registration in other provinces and territories on your behalf.
ABSA DOES NOT ACCEPT ELECTRONIC APPLICATIONS AT THIS TIME
ADMINISTRATIVE SUBMISSION REQUIREMENTS
The following documentation is required for ABSA to register a vessel design and to apply for registration in other provinces on your behalf:
- One (1) completed Design Registration Application Form AB-31 and Form AB-31a for each separate design submitted to ABSA. On this application check all jurisdictions for national registration or indicate which additional jurisdictions you require for registration. Place this form on top of the application packages.
- Two (2) sets of drawings for each separate design application for national registration.
Note: Nova Scotia, New Brunswick, PEI, Newfoundland, Yukon, NWT and Nunavut are covered under one jurisdictional review and they are processed by ACI Central Inc.
For example: if registration is required across Canada, a total of fourteen (14) sets of documents are required. (i.e. two each for BC, Alberta, Saskatchewan, Manitoba, Ontario, Quebec and ACIC).
- For design registrations in Ontario, the drawings must be stamped and signed by a professional engineer that is registered with the Professional Engineers Ontario (PEO).
- For design registrations in Quebec and ACI Central Inc. The drawings must be stamped and signed by a professional engineer.
A professional engineer is person who is registered as a professional engineer in a professional organization and authorized to practice engineering in any province or territory in Canada or any state in the United States of America.
- One (1) set of calculations for each separate design application for national registration. Single sided pages only with no staples.
For example: if registration is required across Canada, a total of seven (7) sets of documents are required. (i.e. one each for BC, Alberta, Saskatchewan, Manitoba, Ontario, Quebec and ACIC).
- ALL documents larger than 8 ½” BY 11” MUST BE FOLDED
- DO NOT SUBMIT APPLICATIONS IN BINDERS, FOLDERS OR DUOTANGS
- Mail applications to:
Attn: Design Survey
9410 20 Avenue NW
Edmonton, AB T6N 0A4
NATIONAL REGISTRATION PROCESS
Process step 1
Apply for and obtain an Alberta boiler or pressure vessel registration. Once your application has been reviewed and accepted for registration in Alberta, you will be invoiced and your ABSA stamped set of documents will be returned to you.
Process step 2
ABSA will apply for and submit your documents to the selected jurisdictions as specified on the AB-31 form for their review.
Process step 3
Once all the registrations for the other jurisdictions are received, they will be forwarded to the submitter and submitter will then be invoiced.
- ABSA will pay the applicable registration fees to the other jurisdictions on your behalf. Once the National Registration is complete, ABSA will invoice the submitter for the other jurisdiction registration fees, plus an ABSA one time administration fee of $560.26, despite how many jurisdictions the submitter applies for.
- Courier and handling charges will be invoiced for each jurisdiction for which registration is requested.
- GST will be charged where applicable.
ABSA can not confirm the registration and review processes fees in advance because they vary by jurisdiction.
An additional fee may apply if the request to register in other jurisdictions is received after the Alberta registration has been completed.
Where possible, ABSA will answer any questions that may arise from other jurisdictions relating to your application. If we are unable to provide the answer, ABSA will then contact the submitter directly for a response.